Pure Water ULTIMA 888 Installation Manual download pdf (Page 13)

Preparing for Installation . . .

Preparing the MiniSoft

The mini-softener may contain fines or particles of resin which are small enough to pass through

the mini-softener and be carried to the boiling tank in the feed water. These are a result of ship-

ping.

We recommend you rinse the fines from the softener

prior to installing the ULTIMA unit at the customers

location. To rinse the fines:

1. Remove the mini-softener from the packaging

carton and inspect the unit and fittings for possible

shipping damage. Remove the small plugs from

the inlet and outlet fittings. To remove the plugs

from the fittings, follow the instructions on page 6.

2. Cut and connect a piece of 1/4” tubing from the

Feed Water to the top of the mini-softener.

3. Cut and connect a piece of 1/4” tubing from the

base of the mini-softener to the drain.

4. Allow approximately 8 liters (2 gallons) to flow out

of the tubing to a drain until it is clean and free of

resin fines.

5. Remove the piece of tubing from the top of the

mini-softener. Connect tubing from the inlet to the outlet on the minisoft (This will prevent the

minisoft from drying out which can cause damage to the resin). The softener is now ready to

be transported to the installation site.

Preparing the VOC Post Filter

Included with each ULTIMA unit is a V.O.C. post filter. The post filter serves to improve the taste of

the water, and remove any stray volatile contaminants from distillation.

1. Remove the post filter from the package.

2. Connect the speedfit elbow with a piece of 1/4” tubing to a distilled water source.

3. Run Distilled water through the filter until there is a clear stream of water.

Figure 20

Rinse fines

down a

Drain

Inlet from

Raw Water

Source

Page 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Pure Water ULTIMA 888 Installation Manual Page 13